Auto-zone-control-systems CommLink IV Technical Guide, Installation Instruct Uživatelský manuál stáhnout pdf (Strana 13)

CommLink IV Technical Guide

Operator Interface

8. In the Network Conﬁ guration selection box, select the type

of CommLink you are using. This will be either Multiple

Loop Conﬁ guration or Single Loop Conﬁ guration.

9. Click

<Exit> to close out of the Job Sites Window.

10. Click the <OFFLINE> button to go

<ON LINE>.

11. From the <Communications> menu, select <Search

for Units>

12. The Search for Installed Units Window will pop up. Click

<Start Search> to initiate an automatic detection of all

installed controllers on your system.

Prism II Setup Instructions

13. If everything is working correctly, Units Found on this

Loop should increment.

14. If Units Found on this Loop stays at zero, check the wiring

to the CommLink IV and the AHU/RTU Controllers and/

or read through these directions again to make sure all steps

were followed.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Žádné komentáře

Auto-zone-control-systems CommLink IV Technical Guide, Installation Instruct Uživatelský manuál Strana 13