Auto-zone-control-systems IP Module Kit Installation Guide for the IP Module Uživatelský manuál stáhnout pdf (Strana 4)

IP MODULE

Technical Guide

Quick Start Guide

NOTE: Please note, the R(+) and T(-) terminals on the

communications terminal block are reversed from all

previous versions of the CommLink.

WARNING: If you are replacing an earlier version of the

CommLink with a CommLink 5, be aware that the polarity

of the terminal block is reversed on the CommLink 5

from all previous models. You must always conﬁ rm that

the polarity is correct when wiring 24 VAC power to the

CommLink power terminal block or serious damage to the

product will result.

Follow the steps below to get your IP Module up and running

in no time.

Step 1: Open your CommLink and snap in your IP

Module. See Figure 1, page 5 for CommLink IV

directions and Figure 2, page 6 for CommLink 5

directions.

Step 2: Set your CommLink’s communication switch to

Multiple or Single. See Figure 3, page 7 for

CommLink IV directions and Figure 4, page 8

for CommLink 5 directions.

Step 3: Set your CommLink 5’s Baud Rate switch to High

or Low. See Figure 5, page 9.

Step 4:

Wire your CommLink to the appropriate controller

on your system and plug the CommLink into a

power supply. See Figure 6, page 10 for

CommLink IV directions and Figure 7, page 11

for CommLink 5 directions.

Step 5: Connect your CommLink to your PC via

Ethernet cable. See Figures 8 & 9, page 12.

Step 6: Change your PC’s IP address. See Figure 13,

page 13.

Step 7: Change the IP address of your CommLink. See

page 14 for instructions.

Step 8: Set the baud rate for your CommLink in

the Conﬁ guration Settings. See page 14 for

instructions.

IMPORTANT NOTES:

 Follow the included CommLink connection and

wiring instructions sheet (See Figure 6, page 10 or

Figure 7, page 11) to connect and conﬁ gure the

CommLink for an Ethernet connection.

 Make sure you follow the appropriate directions for

your Windows

version.

 Familiarize yourself with all system components and

review all documentation. Pay special attention to

“Cautions,” “Notes,” and “Warnings” since these may

keep you from experiencing unnecessary problems.

 If you encounter any problems, please refer to the

Troubleshooting section of this guide ﬁ rst. If you

can’t resolve the problem, please call WattMaster

Technical Support at our toll free number—

1-866-918-1100.

1 2 3 4 5 6 7 8 9 ... 19 20

Komentáře k této Příručce

Žádné komentáře

Auto-zone-control-systems IP Module Kit Installation Guide for the IP Module Uživatelský manuál Strana 4

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Auto-zone-control-systems IP Module Kit Installation Guide for the IP Module