Auto-zone-control-systems USB-Link 2 Technical Guide, Installation Instructi Uživatelský manuál stáhnout pdf (Strana 5)

USB-Link 2

Technical Guide

USB Serial Converter and Serial Port

Driver Installation

The internal USB communication port of the USB-Link 2 uses a

specialized driver that must be installed on your Windows PC before

communication to the device can be established.

NOTE: You may already have this driver installed on your PC if

you are using a CommLink 5.

1. Before you begin, you must determine if your computer

is running 32-bit or 64-bit Windows. Open the System

information by clicking the

<Start> button, clicking

<Control Panel>, and clicking <System>. Under

System, you can view the system type. Based on what

type of system you have, you will choose 32_Bit.exe or

64_Bit.exe from the list of ﬁ les shown in Step 10.

2. Insert the USB Drivers CD-ROM into your CD-ROM

drive or download the USB Drivers ﬁ le from www.

orioncontrols.com/a/software/. If using the CD-ROM,

go to Step 7. If downloading the ﬁ le, you will need to

scroll down the page until you ﬁ nd “USB Drivers For

All Products” to download the driver ﬁ les.

3. Right click on “Click Here.” Then click

<Save Link

As> or <Save Target As> and select Desktop as the

destination.

4. Go to the “USB-DRIVERS-ALL.exe” ﬁ le on your desk-

top. Double-click on this ﬁ le and choose “Run” from the

options list. The following window will appear:

5. Select

<Unzip> and the ﬁ le will be unzipped to the

folder C:\Temp\WM-USB-Drivers folder by default.

6. Next, go to the C:\Temp\WM-USB-Drivers folder and

now go to Step 9.

7. Click your

<Start> button and then click, <Computer>.

8. Double-click on your CD-ROM drive. Open the Media

Files Folder.

9. Double-click the folder “USBLink NewSS0073”.

10. The following list of ﬁ les will display. Choose 32_Bit.

exe or 64_Bit.exe based on what type of system you

determined you have in Step 1.

11. In the window that pops up, shown below, click

<Next>

and the installation program will walk you through the

rest of the steps.

12. When successful installation has occurred, connect the

USB cable between the PC and the USB-Link 2. The

PC will automatically recognize the device and a COM

port will be assigned.

Follow the procedures on page 7 to

verify the Comm Port.

USB Driver Installation

Revised 10/24/14

1 2 3 4 5 6 7 8 9 10 ... 18 19

Komentáře k této Příručce

Žádné komentáře

Auto-zone-control-systems USB-Link 2 Technical Guide, Installation Instructi Uživatelský manuál Strana 5

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Auto-zone-control-systems USB-Link 2 Technical Guide, Installation Instructi